4.0SAM2000GV MANAGEMENT
Once your SAM2000GV has been installed, bandwidth and other configurations are software selectable via your IP DSLAM's MUM. Dependent upon the MUM model installed, the SAM2000GV may be configured via Command Line Interface (CLI), Simple Network Management Protocol (SNMP) and/or Net to Net Technologies'
If your IP DSLAM is newly installed, configuration of the DSLAM's IP Address, Subnet Mask and Gateway must be completed, via CLI or NMS, before you will be able to access management data or configure any other parameters. Refer to the CLI Management User Guide (http://www.nettonet.com/support/docs/210- 0000052) or to the NMS Management User Guide (http://www.nettonet.com/support/docs/210-
0000048) for initial configuration instructions.
NOTE If you have an IPD12000 with two MUMs, configuration alterations can be made to a SAM2000GV through either MUM; most configuration(s) will be saved to the NVRAM of both. Refer to your MUM Installation Instructions for specifics.
4.1Via Command Line Interface (CLI)
4.1.1Establish a Connection With Your IP DSLAM
Establish a connection between your IP DSLAM and your PC, either directly (through the COM port on the MUM faceplate) or, if your DSLAM has been configured to allow inband management, across your local network.
4.1.2Launch Your Terminal Emulator
Launch a terminal emulator program on your PC. Net to Net Technologies' copyright information will appear on your screen, followed by a request for username.
4.1.3Log In
Log in with your assigned username and password. For SAM2000GV configuration, you must log in as a superuser (general users have read only access). If your username and/or password are unknown, contact your System Administrator or Information Technology Manager for assistance.
Once you have logged in as a superuser, you will be able to make configuration changes to the SAM2000GV, and any other interface modules installed in your IP DSLAM, as desired. For more detailed information regarding SAM2000GV configuration via CLI, refer to Net to Net's CLI Management User Guide:
4.2Via Net to Net's Network Management System (NMS)
4.2.1Establish a Connection With Your IP DSLAM
Establish a connection between your IP DSLAM and your PC, either directly (through the 10/100 Ethernet MGMT port on the MUM faceplate) or, if your DSLAM has been configured to allow inband management, across your local network. For direct connections, verify that the MGMT LNK LED on the MUM faceplate is illuminated.
