CONNECTING AN EXTERNAL DC SOURCE FOR
AUTOMATIC TURN ON-OFF
7
To automatically turn on and off the A 51 with an external DC voltage, choose the DC Triggering option by moving the Auto Turn On switch on the rear panel to its lower 12V position.
2.5 mm
What You’ll Need:
•A cable with a 2.5 mm
•A “control” component with +9Vdc to +12Vdc trigger voltage
Before Connecting
❑Remove Power to all the components in your audio system.
❑Make sure the Auto Turn On switch on the A 51 rear panel is in its 12V (down) position.
To Connect
1Plug one end of the trigger wire into the 12V Input jack on the A 51.
2Plug the other end of this wire into the external DC source.
Input Select
Balanced Unbalanced
A51 Amplifier | Ch 1 |
Parasound Products, Inc.
San Francisco, CA USA
L U C A S F I L M
Manufactured under license from Lucasfilm Ltd. Lucasfilm and THX are registered Trademarks of Lucasfilm Ltd.
WARNING
To Prevent Fire Or Shock
Ch 2
Ch 3
Ch 4
Fuse
Hazard, Do Not Expose ThisCh 5
Unit To Rain Or Moisture.
CAUTION |
|
|
|
|
|
To Prevent Electric Shock, |
|
|
|
|
|
Do Not Remove Cover. No |
|
|
|
|
|
|
|
|
|
| |
Refer Servicing To Qualified |
|
| Audio |
|
|
Service Personnel. |
|
|
| Lift | |
|
| Man |
|
| |
| 1 | Input | 12 V | 50 mV 250 | Normal |
|
| Sensitivity |
| ||
|
| Auto Turn On | Ground | ||
Auto Turn On Switch, set to down position
2
CONTROL
COMPONENT
Output
| AC 115V | 60Hz |
| AC 230V | 50Hz |
Power Consumption: 1800W
CONTROL
COMPONENT
YOU SHOULD KNOW
If the device you want to use to control your A 51 doesn’t have a 2.5 mm trigger output connector, you can cut one plug off the cable and terminate the end as required. The lead with the red stripe is positive and the lead without the stripe is negative.
