Introduction
Congratulations on your purchase of this precision audio component and thank you for your selection of Parasound. The Parasound
Unpacking Your Amplifier
Carefully unpack your amplifier and remove all the enclosed accessories. Be sure to inspect the unit for any possible shipping damage. If you see any, contact your Parasound Dealer immediately. Save all the packing material in case you need to ship the amplifier for repair. Before you proceed, find the serial number located on the rear panel of your amplifier and record it here for reference:
Serial #____________________ | Date of Purchase____________________ |
Installing and Rack Mounting Your Amplifier
Place your amplifier away from heat sources such as air ducts and radiators. Always mount the amplifier horizontally and make sure that your cabinet or shelf can support its weight. It is best to provide a separate shelf for your amplifier rather that stacking it directly above or below other components.
With the use of the optional Parasound
Ventilation Requirements for Your Amplifier
To insure safe and reliable operation, it is very important that the amplifier has plenty of ventilation to prevent overheating and automatic shut down from its thermal protection circuitry. Please observe the following ventilation guidelines when installing your amplifier in a cabinet or other enclosed area:
1)If you are not using a fan, allow at least six inches on each side and above the amplifier, and do not close off the front with a cabinet door or panel.
2)If you are enclosing the amplifier within an equipment cabinet, use a fan to draw in cool air and exhaust warm air. Two vent holes are required: one for intake and one for exhaust.
3)Do not place the amplifier on carpeting that will obstruct the air flow into the bottom of the amplifier chassis and heatsinks.
4)Avoid stacking components. If you do stack components, you must use a fan to circulate the warm air that will quickly become trapped between them when they are powered on.
Making Connections to Your Amplifier
Leave the AC cord disconnected while making any input or speaker connections. When making connections to the amplifier, make sure there is no strain or tension on the input leads, speaker wires, or AC cord that could cause them to pull loose.