Introduction / General safety advice for electrical power tools
Technical data
Model: | PET 25 | |
Rated voltage: | 230 V ~ 50 Hz | |
Firing speed: | 30 / min | |
Max. 15 min | ||
Protection class: | II / | |
| Staple width: | 6 mm |
| ||
| Staple length: 15 - 25 mm | |
Type 55 |
|
|
15 - 25 mm |
|
|
| Nail length: | 15, 20, 25, 32 mm |
| ||
Type 47 15, 20, 25, 32 mm
Noise and vibration data:
Measured values for noise are determined in accord- ance with EN 50144. The
Sound pressure level: | 83.1 dB(A) |
Sound power level: | 91.3 dB(A) |
Uncertainty K: | 2.5 dB |
period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working.
General safety advice for electrical power tools
WARNING! Read all the safety advice and instructions! Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC- TIONS IN A SAFE PLACE FOR FUTURE REFER- ENCE! THE TERM “ELECTRICAL TOOL” USED IN THE SAFETY ADVICE REFERS TO ELECTRICAL TOOLS POWERED BY MAINS ELECTRICITY (BY MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTER- IES (WITHOUT A MAINS LEAD).
Wear hearing protection!
Vibration total values determined according to EN 50144:
Vibration emission value ah = 5,615 m/s2, Uncertainty K = 1.5 m/s2.
WARNING! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 50144 and can be used to compare devices.
Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical pow- er tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular
1. Workplace safety
a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.
b)Do not work with the device
| in potentially explosive envi- |
| ronments in which there |
| are inflammable liquids, gases or |
| dusts. Electrical power tools create sparks, |
| which can ignite dusts or fumes. |
c) | Keep children and other peo- |
| ple away while you are op- |
| erating the electrical tool. |
| Distractions can cause you to lose control of |
| the device. |
GB/IE/CY
7
