Before use / Use / Maintenance and cleaning / Service
Before use
Loading the magazine
Squeeze the end of the magazine slider 4 (see Fig. A).
Pull the magazine slider 4 out of the magazine
5(see Fig. B).
Fill the magazine 5 with staples or nails (see Fig. C).
Note on filling with nails: Use the right- hand slot for filling with nails as shown in the detailed image in Fig. C. Ensure that the nail heads are all at the top.
NOTE: Observe the maximum capacity of ap- prox. 85 staples or approx. 75 nails when filling. After filling, push the magazine slider 4 into the magazine 5 as far as it will go until you hear and feel it engage.
NOTE: The magazine filling level indicator 6 allows you to see whether there are still staples in the magazine.
Stapling / nailing
Switch the device on by setting the ON / OFF switch 2 to position “I”.
Press the device with its front plate 7 at the point on the surface of the material where you wish to staple or nail.
Press the trigger 1 .
NOTE: The integral safety lock in the front plate prevents unintentional firing.
Troubleshooting
Cause:
A staple or nail is blocking the device.
Solution:
Open the magazine slider 4 . This releases the pretension. Release the screws on the front plate 7 using the Allen key (Fig. D).
Remove the staple or nail.
Setting the impact force
NOTE: Select the lowest impact force necessary for your stapling.
Take into account the length of the staples or nails to be used and the strength of the materials to be joined.
Turn the impact force controller 3 in the 
direction / anticlockwise to increase the impact force.
Turn the impact force controller 3 in the 
direction / clockwise to decrease the impact force.
Use
Switching on and off
Set the ON / OFF switch | 2 | to position “I” to |
switch on the device. |
|
|
Set the ON / OFF switch | 2 | to position “0” to |
switch off the device. |
|
|
Maintenance and cleaning
WARNING! DANGER OF INJURY! Pull the mains plug out of the mains socket before you clean or maintain the device.
The electric nailer / stapler is designed to be main-
Always keep the device clean, dry and free from oil or grease.
Clean the device immediately after you have finished using it.
Do not allow any liquids to enter the device. Use a cloth to clean the housing. Never use petrol, solvents or cleaning agents that might attack plastic.
Service
WARNING! Have your device repaired at the service centre or by qualified specialist personnel using
10 GB/IE/CY
