Advice on use / Maintenance and cleaning / Disposal
Example of | DIN guidance |
material | value |
|
|
Car body paint | |
|
|
Acrylic paint | |
|
|
Synthetic resin paint | |
|
|
Primer | |
|
|
QSwitching On/Off
Switching on
jTo start the device, press the ON/OFF switch 3 and keep it pressed.
Switching off
jTo switch off the device, release the ON/OFF switch 3 .
QSpraying process
The surface to be sprayed must be clean, dry and free of grease.
Observe the safety advice!
1.You can vary the spray by adjusting the regulator button 2 (see Fig. D). The spray is correctly set when no drops are formed and the gun produces a fine, consistent spray pattern.
2.Do not switch the device on or off over the area being sprayed. Begin and end the spray process approx. 10 cm beyond the area being sprayed.
3.The spray process should follow the sequence shown in Fig. E – keep the spray gun moving parallel to the surface
–Do not incline the spray gun
–Move the spray gun at a constant speed
–Apply the sprayed medium as thinly as possible
–The layer(s) of sprayed medium need(s) to be allowed to dry for some time before you apply the next coat Fig. F) at right angles to the previous coat.
4.Do not allow the paint cup to empty complete- ly while spraying – drops may form!
QMaintenance and cleaning
General advice
1.
Warning! Pull out the mains plug be- fore you carry out any tasks on the spray gun. Do the same when you take a break from spraying.
2.After each use, spray thinners (in the open air only – danger of explosion!) or water through the device.
3.To protect from rust after cleaning, you can spray sewing machine oil through the device.
4.
Warning! Never immerse the device in the cleaning medium.
5.Never use inflammable solvents to clean the device.
Cleaning instructions
1.Unscrew the attachment screw 1 , see Fig. A.
2.Take off the pump housing 10 downwards.
3.Unscrew nozzle 8 and remove the suction- pressure valve 9 .
4.Take the pump piston 4 and spring 5 out of the pump housing 10 .
5.Clean parts 4 , 5 , 8 , 9 with thinners.
6.Fit the components back in reverse order.
QDisposal
The packaging is wholly composed of
Do not dispose of electrical power tools with the household rubbish!
In accordance with European Directive 2002 / 96 / EC (covering waste electrical and electronic equipment) and its transposition into national legislation, worn out electrical power tools must be collected separately and taken for environmentally compatible recycling.
Contact your local refuse disposal authority for more details of how to dispose of your worn out electrical devices.
10
GB
