General safety advice for electrical power tools / Operation

J Warning! DUST HAZARD! Any harmful / noxious dusts generated from machin- ing represent a risk to the health of the person operating the device and to anyone near the work area.

Wear a dust mask!

J Warning! NOXIOUS FUMES! Ensure that there is adequate ventilation when machining surfaces containing plastic or cov- ered with paint, varnish etc.

JDo not soak the materials or the sur- face you are about to work on with liquids containing solvents.

JAvoid abrading paints containing lead or other substances hazardous to health.

JDo not machine materials containing asbestos. Asbestos is a known carcinogen.

JDo not machine moist materials or damp surfaces.

NOTE! Do not allow the tool to come to a standstill by overloading it!

J Warning! Switch the device off and allow it to come to a standstill be- fore you put it down.

J Warning! Always keep the device clean, dry and free of oil or grease.

JChildren or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must never be allowed to play with the device.

QOperation

Take note of the mains voltage:

The mains voltage at the mains socket must match that shown on the rating plate on the device. Devices marked with 230 V can also be operated at 220 V.

JNever use the device for a purpose for which it was not intended or with non-original parts / ac- cessories. The use of tools or accessories other

10 GB/IE/CY

than those recommended in the operating in- structions could lead to you suffering an injury.

QInserting or replacing a tool / collet

jPress the spindle lock 6 and keep it pressed.

jRotate the clamping nut 4 until the lock engages.

jLoosen the clamping nut 4 with the combina- tion key 23 .

jIf a tool is already inserted, remove it.

jFirst insert the tool you wish to use though the clamping nut 4 before you insert it into the collet 18 suitable for the tool shaft.

jPress the spindle lock 6 and keep it pressed.

jInsert the collet 18 into the threaded insert and tighten the clamping nut 4 on the thread using the combination key 23 .

Using the Insertion tool with mandrel 12 : Note: Use the screwdriver end of the combi- nation key 23 to release or tighten the screw of the mandrels 12 .

jInsert the mandrel 12 into the electrical tool as described.

jWith the aid of the combination wrench 23 , unscrew the screw from the mandrel 12 .

jPlace the insertion tool you wish to have onto the screw between the two washers.

jWith the aid of the combination wrench 23 , tighten the screw on the mandrel 12 .

QSwitching on and off /  Setting the speed range

Switching on / Setting the speed range:

jConnect the plug 3 to the power supply unit

9by inserting it into the plug-in device 7 provided for such purposes (see Fig. C).

jConnect the device to the power supply by inserting the mains plug into the socket.

jSet the On / Off switch 1 to a position between “5” and “20”.

Page 9
Image 9
Parkside PMGS 12 manual Inserting or replacing a tool / collet, Switching on and off / Setting the speed range