Preparing for use / Operation / Maintenance and cleaning
Attaching the guide fence | Setting the pendulum action |
The guide fence 19 can be attached on the left or right side of the device (see Fig. A).
Release the two locking screws of the fence guide openings 15 .
Slide the guide fence 19 into the fence guide openings 15 .
Retighten the two locking screws.
Connecting the vacuum sawdust extraction device
Insert the dust extraction spout 7 into the vacuum extraction duct 8 until it engages. Connect a vacuum device approved for the extraction of sawdust and splinters to the dust extraction spout 7 (see Fig. C).
Operation
Setting the cutting angle
Release the clamp screw 11 using the Allen key 20 .
Set the cutting angle 0° / 15° / 30° / 45° (left / right) on the base plate 9 . The embossed marking for each recessed line indicates the cutting angle setting. The housing has a stop pin 21 (see Fig. B) which must engage in the appropriate recessed line.
Tighten the clamp screw 11 using the Allen key 20 .
Setting the speed
Set the desired speed using the oscillation speed setting wheel 4 .
If possible always determine the optimum setting beforehand by carrying out a practical test.
You can set the pendulum movement of the saw blade 14 using the pendulum action switch 12 . By having no pendulum action (setting “0”) you can produce fine, clean cut edges. Turn off the pendulum action for thin workpieces.
With the pendulum action activated (settings 1 – 3) you can cut through the workpiece at increasingly quicker rates.
If possible always determine the optimum set- ting beforehand using a practical test.
Switching On / Off
DANGER! Before connecting to the mains plug check that the mains circuit supplies
230 V ~ 50 Hz and is fitted with a 16 A fuse or
Switching on:
Push the ON / OFF switch 2 into position “I” and ensure it engages.
Switching off:
Press the rear part of the ON / OFF switch 2 .
Maintenance and cleaning
Maintenance
Replace the saw blade 14 as soon as its teeth become blunt and it starts to produce defective saw cuts.
Cleaning
Carry out that cleaning of the device when you have finished sawing.
GB/IE/CY 11
