Introduction / General safety advice for electrical power tools
| Included items | values given in these instructions. It is easy to underes- | ||
|
|
|
| timate the vibration load if the electrical power tool is |
1 | Jigsaw including | used regularly in particular circumstances. | ||
| - Dust extraction spout |
| ||
| - Allen key | Note: If you wish to make an accurate assessment | ||
| - Chip guard | of the vibration loads experienced during a particu- | ||
1 | Guide fence | lar period of working, you should also take into | ||
1 | Operating instructions | account the intervening periods of time when the | ||
|
|
|
| device is switched off or is running but is not actual- |
|
|
|
| ly in use. This can result in a much lower vibration |
|
|
|
| |
|
|
|
| load over the whole of the period of working. |
2Saw blades for wood
1 Saw blade for metal
Technical information
Jigsaw: | Parkside PPHSS 730 SE |
Rated voltage: | 230 V ~ 50 Hz |
Power consumption: | 730 W |
max. n0 600 - 2900 | |
Cutting depth: | max. 110 mm |
Pendulum action: | 3 speeds and a fine |
| cutting setting |
Inclined cut: | 0 - 45° left / right |
Protection class: | II / |
Noise and vibration data:
Values determined in accordance with EN 60745. The sound pressure level
Wear ear protection!
Evaluated acceleration, typical: Hand / arm vibration ah = 6,268 m / s2 Uncertainty K = 1,5 m / s2
WARNING! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibra- tion levels and in many cases they may exceed the
General safety advice for electrical power tools
WARNING! Read all the safety advice and instructions! Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC- TIONS IN A SAFE PLACE FOR FUTURE REFER- ENCE! THE TERM “ELECTRICAL TOOL” USED IN THE SAFETY ADVICE REFERS TO ELECTRICAL TOOLS POWERED BY MAINS ELECTRICITY (BY MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTER- IES (WITHOUT A MAINS LEAD).
1. Workplace safety
a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.
b)Do not work with the device
in potentially explosive envi- ronments in which there
are inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes.
c)Keep children and other peo-
ple away while you are op- erating the electrical tool.
Distractions can cause you to lose control of the device.
GB/IE/CY
7
