General safety advice for electrical power tools / Operation
cutting edges are less likely to jam and are easier to control.
g)Use the electrical power tool, accesso- ries, inserted tools etc. in accordance with these instructions and advice, and the stipulations drawn up for this par- ticular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those in- tended can lead to dangerous situations.
Safety instructions for motor carving devices
Original Accessories /
Additional Equipment
Use only the accessories and additional equipment referred to in the instruc- tions. The use of tools or other accessories which are not recommended in the instructions may represent a risk of injury.
Operation
Turning the Device On / Off
Insert the mains plug into a socket.
In order to avoid injury, fire and health hazards:
Secure the work piece. Use clamping devices / a vice to hold the work piece. It is then held more securely than with your hand.
Wear protective goggles! There is a danger of injury from splintering materials flying into your
eyes etc.
Switching on:
Press the ON / OFF switch position.
Switching off:
Press the ON / OFF switch position.
1
1
to the “I”
to the “0”
Wear a dust mask! During pro- longed working with wood and par- ticularly if materials are processed
which produce dusts that are hazardous to the health.
Do not soak materials or areas which are to be worked on with
Material containing asbestos must not be processed with this device. Asbestos is a known carcinogen.
Under no circumstances should you prop up your hands next to or in front of the device or the area to be worked on. There is a danger of injury from the very sharp attachment tools.
Always route the cable towards the back away from the device.
In cases of danger remove the plug from the socket immediately.
Inserting / Replacing Blades
WARNING! DANGER OF INJURY! Before performing any work on the device, turn the device off and remove the mains plug.
WARNING! DANGER OF INJURY! The carving blades have a very sharp edge.
During assembly and the final check of the blade you should wear ap- propriate protective gloves.
The selection of the correct carving blade depends on the specific application. The carving blades sup- plied are suitable for the most common applications (see Figures B - D).
Release the cap nut 6 with the key 8 in an anticlockwise direction.
Remove the blade if necessary. Insert another
blade into the tool holder | 5 | as far as it will go. | |||
| with the key |
| in a | ||
6 | 8 | ||||
clockwise direction. |
|
|
|
| |
GB/IE 9
