Parkside 6-LIA Original ancillaries / accessories, Changing the bits / screwdriver bit inserts

General safety advice for … / Before first use/  Preparing the tool for use

hold the electrical power tool by the insulated handle areas only. Contact with a live wire means that the metal parts of the electrical power tools may become live and this can result in an electric shock.

JBefore you carry out any tasks on the device, transport or store it, make sure that the direction of rotation switch is in the middle position (lock). To prevent the device from starting up uninten- tionally.

QOriginal ancillaries /  accessories

JUse only the ancillaries and accessories that are detailed in the operating instructions. The use of ancillaries and ac- cessories other than those recommended in the operating instructions could lead to an in- creased risk of personal injury for you.

QBefore first use

QCharging the rechargeable battery on the device (see Fig. D)

Note: The battery is supplied partially charged. Charge the battery for at least three hours before first use. You can charge the Li-Ion battery at any time without risk of shortening battery life. Interrupt- ing the charging process does not damage the battery.

Starting the charging process:

jConnect the mains adapter 10 to a 230 / 240 V ~ 50 Hz mains socket.

jConnect the mains adapter 10 to the charging socket on the device 5 .

The rechargeable battery is charged when the battery indicator 3 changes from red to green.

10 GB

Ending the charging process:

jDisconnect the mains adapter 10 from the mains socket.

jDisconnect the mains adapter 10 from the charging socket on the device 5 .

QChanging the bits /  screwdriver bit inserts

Insertion:

jInsert the bit directly into the tool holder 9 .

Removal:

jPull out the bit out of the tool holder 9 .

QPreparing the tool for use

QSwitching on / off the cordless screwdriver

Switching on:

jTo start the appliance squeeze on the ON /  OFF switch 7 and then keep it pressed down.

Switching off:

jTo stop the appliance, release the ON / OFF switch 7 .

QChanging the direction of rotation

Clockwise:

jSlide the direction of rotation switch 1 to the left.

jPress the ON / OFF switch 7 . The direction indicator (clockwise) 2 illuminates. You can now screw in the screws.

Anticlockwise:

jSlide the direction of rotation switch 1 to the right.

jPress the ON / OFF switch 7 . The direction in- dicator (anticlockwise) 4 illuminates. You can now screw out the screws.