Secondary Hole

Locking/Release Button in Primary Hole

For optional attachments, see the AS- SEMBLY section of the applicable attach- ment instruction manual.

ATTACHING THE HANDLEBAR

DANGER: To avoid serious injury, the barrier portion of the handlebar must be installed as shown to provide a barrier between operator and the spinning blade.

1. Locate the decal on the handlebar. This

decal includes an arrow. Position the han-

dlebar with the mounting bracket at the

end of the arrow.

NOTE: A one-half twist is built in the shoul- der strap to allow the strap to rest flat on the shoulder.

2.Adjust the strap, allowing the hook to be about 6 inches (15 cm) below the waist.

3.Fasten the strap hook to the clamp located between the trigger handle and the handle- bar clamp base and lift the tool to the operat- ing position.

4.Try on shoulder strap and adjust for fit and balance before starting the engine or be- ginning a cutting operation.

NOTE: It may be necessary to relocate the shoulder strap clamp on the shaft for proper balancing of unit.

TO RELOCATE SHOULDER STRAP CLAMP:

1.Loosen and remove both clamp screws.

2.Place the upper shoulder strap clamp over the shaft.

3.Position the lower shoulder strap clamp under the shaft and align the upper and lower clamp screw holes.

2. Align hole in handlebar with pin on mount-

ing bracket.

Pin

Mounting

Bracket

Lower Shoulder Strap Clamp

Upper Shoulder

Strap Clamp

Screws

3.Position the bracket cover over the han- dlebar. Again make sure the handlebar is at the end of the arrow.

4.Insert screws and hand tighten only. Be sure the handlebar is installed correctly; then, tighten each screw securely with the hex wrench.

Handlebar Screw

4.Insert two screws into the screw holes.

5.Secure shoulder strap clamp by tighten- ing screws with a hex wrench.

HARNESS

ADJUSTMENT

FOR BALANCE

Bracket Cover

Mounting

Bracket

ASSEMBLY OF SHOULDER STRAP

Proper shoulder strap and handlebar adjust- ments must be made with the engine com- pletely stopped before using unit.

1.Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist.

15cm below waist

6

 

10 -- 30 cm

 

above

76 cm

ground

 

 

Page 6
Image 6
Partner Tech T330+ instruction manual Attaching the Handlebar, To Relocate Shoulder Strap Clamp, Assembly of Shoulder Strap