Manuals
/
Pass Labs
/
Home Audio
/
Stereo Amplifier
Pass Labs
pre-amplifier owner manual passTM
Models:
pre-amplifier
1
1
12
12
Download
12 pages
22.22 Kb
1
2
3
4
5
6
7
8
<
>
Specs
Warranty
at “Unity” both left and right level controls on the X0.2 will have a displayed value of 54, and any previous balance settings will be lost. Both of these default conditions are intentional, and intended to make the most advantageous use of your source electronics. You may also set any of the four inputs to unity 0dB gain by manually setting the volume of that input at
signal typically adds additional gain stages and degrades the inherent noise and distortion superiority of balanced signal, coloring what you eventually hear
The pre-amplifierconsists of three machined aluminum chassis it has five sets of input connections, two sets of outputs, both single- ended and balanced, a tape loop and a full function remote control unit that mirrors the front panel functions
Page 1
Image 1
pass
TM
May 18, 2006
X0.2 Owner’s Manual
1
Page 2
Page 1
Image 1
Page 2
Contents
passTM
Wayne Colburn
Introduction
The pre-amplifierconsists of three machined aluminum chassis it has five sets of input connections, two sets of outputs, both single- ended and balanced, a tape loop and a full function remote control unit that mirrors the front panel functions
signal typically adds additional gain stages and degrades the inherent noise and distortion superiority of balanced signal, coloring what you eventually hear
There are a total of five inputs, a separate tape loop and two outputs on each of the pre-amplifierchassis. One chassis is exclusively dedicated to right channel and the other exclusively left channel. Balanced inputs and outputs are via XLR connectors. Single- ended inputs and outputs are via RCA connectors. On the XLR connectors, pin 1 is grounded, pin 2 is the positive signal, and pin 3 is the negative signal
Description of Operation
at “Unity” both left and right level controls on the X0.2 will have a displayed value of 54, and any previous balance settings will be lost. Both of these default conditions are intentional, and intended to make the most advantageous use of your source electronics. You may also set any of the four inputs to unity 0dB gain by manually setting the volume of that input at
Product Philosophy Other Design Comments
Page
X0.2 Specifications
Warranty Information
Water and moisture Electrical devices should not be used near water as per example, near a bathtub, washbasin, kitchen sink, laundry tub, wet basement or swimming pool . Care should be taken such that objects do not have the opportunity to fall, and that liquid is never spilled onto or into the device enclosure through openings