6
X250.5 Owners Manual
Do everybody a favor and tr y not to have shorted output cables. It
happens accidentally all the time, and the amplifier is designed to sur-
vive, mostly.
Of course it’s always possible that something could g o wrong. If so,
don’t get excited, just relax. It’s really ag g ravating when something like
this doesn’t work, we understand, but it will get fixed. We g o to a lot
of trouble to make products reliable, and the failure rate of our ampli-
fiers is very low. T his is small comfort to the few, but take it easy and
give us a call if you have problems.
People are often interested in how long it takes for these amplifiers
to break in. Perhaps a more salient question is how long does it take
them to reach their sonic best after turn on. It takes about an hour for
them to fully war m up, and this is where we adjust them first. Then
we adjust them ag ain and ag ain over a couple of days, keeping the bias
and offset in the sweet spot. Our environment is about 23 deg rees
Centig rade and the heat sinks will rise approximately 25 degrees C.
above that, for an average on heat sink temperature of 48 deg rees C.
Sonically they are at their best when the heatsinks are approximately
50 deg rees C.
In your setup the temperature may var y a bit due to line voltag e varia-
tions and ventilation, but this is not a big deal. You should be able to
put your hands on the heat sinks without discomfor t for 10 seconds
or so. It is nor mal for the heasink temperature to var y side-to-side and
front to back.
The amplifier has a ther mal cutout that will disconnect AC power if
the temperature exceeds 75 deg rees Centig rade. This should never
occur in real life.
More things to know
You can remotely operate the stand-by mode by applying 12 volts DC
to the single pair of binding post connectors on the rear of the ampli-
fier. The positive of the 12 volts DC g oes to the red connector. This
connection has an actual operating range of about 9 volts to 15 volts
at a cur rent draw of approximately 5.0mA. This switching will over-
ride the front panel button, so if you want the front panel button to
operate, leave the rear connection open.
So much for the most essential information.
You are ready to play music