Patton electronic user manual Standalone Unit Installation, 1058DV, Rack Card Installation

3.0 INSTALLATION

Because the Model 1058 requires no configuration, it can be installed quickly. If you are installing a standalone unit, refer to section 3.1 “Standal- one unit installation”. Otherwise, refer to section 3.2 “Rack card installation”.

3.1 STANDALONE UNIT INSTALLATION

Do the following:

1.Connect the line interface between the units (refer to section 3.3, “Connecting the Twisted-Pair Line Interface” on page 10)

Note See Figure 2 for the standalone unit’s rear panel arrangements.

2.Connect the Ethernet interface (refer to section 3.4, “Connecting the 10/100Base-T Ethernet Interface” on page 11).

3.Connect the power plug (refer to section 3.6, “Connecting Power” on page 13).

1058DV

1058D

USA

in	the
Made

Power

VLINK

Ethernet

VDSL twisted-pair

POTS/ISDN Ethernet

USA

in	the
Made

Power

VLINK

Power

jack

Ethernet RJ-45 interface port

VDSL twisted-pair

terminal block

interface

POTS/ISDN twisted-pair terminal block interface

Figure 2. Model 1058 standalone rear panel

3.2 RACK CARD INSTALLATION

The Model 1058 rack card version comprises a front card and a rear card.Do the following to install the cards into the rack chassis:

1. Slide the rear card into the back of the chassis along the metal rails.

8