![](/images/new-backgrounds/1186318/1863189x1.webp)
4.0 INSTALLATION
The 2135 is equipped with DTE, Network, and power interfaces. This section briefly describes connnection to each interface.
4.1 CONNECT TO 10BASET ETHERNET PORT
The shielded
1 TD+ (data output from Ethernet)
2 TD- (data output from Ethernet)
3 RD+ (data input to Ethernet)
4 (no connection)
5 (no connection)
6 RD- (data input to Ethernet)
7 (no connection)
8 (no connection)
Figure 3. Model 2135 Ethernet connector pinout
4.1.1 Connect the 10BaseT Ethernet Port to a Hub
The Model 2135 10BaseT interface is configured as DTE
(Data Terminal Equipment). Use the diagram below to construct a cable to connect the 2135 to a 10BaseT Hub.
|
| 2135 10BaseT Hub |
1 | (TX+) | 1 (RX+) |
2 | 2 | |
3 | (RX+) | 3 (TX+) |
6 | 6 |
4.1.2 Connect the 10BaseT Ethernet Port to a PC (DTE)
| 2135 10BaseT DTE | ||
1 | (TX+) | 1 | (TX+) |
2 | 2 | ||
3 | (RX+) | 3 (RX+) |
|
6 | 6 |
4.2 CONNECT TO THE DTE INTERFACE
The DTE interface is a V.35 DTE (M/34 male connector), designed to plug directly into a DCE interface (See Appendix C V.35 Interface Pin Assignments).
4.3POWER CONNECTION
The Model 2135 offers either an AC or DC power supply.
4.3.1 AC Power Supply (100-240VAC)
The Model 2135 uses a 5VDC, 2A universal input
The Model 2135 powers up as soon as it is plugged into an AC outlet. The unit does not have a power switch.
4.3.2 DC Power
The
The Model 2135 10BaseT interface is configured as DTE (Data Terminal Equipment). To connect the 2135 to another DTE such as a 10BaseT network interface card in a PC, construct a 10BaseT crossover cable as shown in the diagram on the following page.
To Power
Supply Jack
Barrel power connector
MADEINCHINABYSUNNY | :G01234567890S/N | OUTPUTPOWER:5WMAX | OUTPUT:+5V1.0A | SWITCHINGPOWERSUPPLY |
| To | |||
Source | |||||||||
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| +Vin |
|
Black lead
Red lead (+V)
7 | 8 |