Patton electronic 460 user manual Installation, Installing the Model, RJ-45 Pins Function

4.0 INSTALLATION

The sections on the next page describe installing the following:

•Model 460 (see section 4.1, “Installing the Model 460” on page 8)

•Model 460-TBP (see section 4.2, “Installing the Model 460-TBP” on page 8)

Refer to the appropriate section to install your unit.

4.1 INSTALLING THE MODEL 460

Do the following:

1.Refer to the pin configuration below when assembling the cable that will connect to the RJ-45 jack.

2.Plug the modular cable connector into the RJ-45 jack.

RJ-45 Pin(s)	Function
1 and 2	TX pair
3	TX shield
4 and 5	RX pair
6	RX shield

3.Connect the coaxial cables to the TX Out and RX In connectors. Congratulations, you have finished installing the Model 460!

4.2INSTALLING THE MODEL 460-TBP

Do the following:

1.Strip the outer jacket insulation from the twisted pairs about 1 inch.

2.Strip back the insulation on each of the wires about 0.25 inches.

8