5.3 LED STATUS MONITORS
The Model IM1/I features two LEDs that monitor general operating status and the
|
|
|
|
|
|
|
|
|
|
|
Status LED |
|
|
|
|
|
|
|
|
| Link LED |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||||
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
Interface Port
| Figure 4. Model IM1/I Panel |
Status | Blinks yellow from one to eleven times to indicate |
| system status. Each pulse pattern is separated by a |
| 2 second “off” period. Greater pulse patterns have |
| higher priority (buffer saturation has greater priority |
| than an empty MAC table). Valid system statuses |
| are: |
| 1 pulse = system status is okay |
| 2 pulses = no MAC entries in the MAC Address Table |
| 3 pulses = Clear to Send (CTS) or Carrier Detect |
| (DCD) from base unit are not asserted |
| 4 pulses = IM1/I buffer is saturated |
| 5 pulses = WAN receive frame(s) too large |
| 6 pulses = WAN receive frame(s) not octet aligned |
| 7 pulses = WAN receive frame(s) aborted |
| 8 pulses = Detected WAN receive frame(s) with CRC |
| 9 pulses = Detected LAN receive frame(s) too large |
| 10 pulses = Detected LAN receive frame(s) not octet |
| aligned |
| 11 pulses = Detected LAN receive frame(s) with bad |
| CRC |
Link | Glows green to indicate good link integrity on the |
|
APPENDIX A
PATTON MODEL IM1/I SPECIFICATIONS
LAN Connection: | |
MAC Address Table Size: | 4096 entries |
MAC Address Aging: | MAC addresses deleted after 8 minutes |
| inactivity |
512 KB RAM; 128 KB FLASH | |
Frame Latency: | 1 frame |
Interface: | |
| QuikConnect™ port on Patton base |
| unit |
LED Indicators: | (1) general status; (1) link integrity |
Power Supply: | +5 Volts @ 510 mA supplied to module |
| by connection to Patton QuikConnect |
| interface |
Temperature Range: | 32 to 122ºF (0 to 50º C) |
Dimensions: | 2.9" x 3.2" (7.4 cm x 8.1 cm) |
Weight: | 0.25 lb (0.11 kg) |
11 | 12 |
