Dimensions (H x W x D):
46.375" x 18.75" x 29.125" (117.8 cm x 47.6cm x 74 cm)
Net Weight:
162 lbs. (73.48 kg)
FEATURES
•Externally switchable,
•Dual
•High power handling polypropylene capacitors
•
•44XT™ Compression driver
•“Lockable” mode select switch
•80° x 40°
DESCRIPTION
The new DTH® 4215f was designed as a true minimum profile enclosure. It measures only
The DTH® 4215f is a
Two Neutrik®
another enclosure, if desired. (If used in this manner, the amplifier must be rated for operation into a 2 ohm load.)
Tough black polyurethane coating covers the DTH® 4215f. This is a low- wear,
All this combines to give you a great looking and great sounding loudspeaker perfectly suited to any sound reinforcement application.
DIRECTIVITY
Beamwidth and directivity factors are derived from the
in the chosen environment. The DTH® 4215f exhibits a desirable beamwidth and directivity factor suit- able for all
FREQUENCY RESPONSE
This measurement is useful in determining how accurately a given enclosure reproduces an input signal. The frequency response of the DTH® 4215f is measured at 1 meter using a 2 volt swept sine input. As shown in Figure 1, the selected drivers in the DTH® 4215f combine to give a smooth frequency response from 50 Hz to 18 kHz.
POWER HANDLING
There are many different approaches to power handling ratings. Peavey rates this speaker system’s power handling using a modified form of the AES Standard
to 20 kHz) pink noise with peaks over four times the RMS level, this strenuous test signal assures the user that every portion of this system can withstand today's
MOUNTING
Five flying points, two aiming points, ATM
ARCHITECTURAL
AND ENGINEERING
SPECIFICATIONS
The loudspeaker system shall have an operating bandwidth of 50 Hz to
18 kHz. The output level shall be 98 dB when measured at a distance of one meter with an input of one watt. The nominal impedance shall be 4 ohms. The continuous power handling shall be 600 watts, with maximum program power of 1200 watts and minimum amplifier headroom of 3 dB. The nominal radiation geometry shall be
80 degrees in the horizontal plane and
80 degrees in the vertical plane. The outside dimensions shall be
162 lbs. The loudspeaker system shall be a Peavey model DTH® 4215f.
ONE YEAR
LIMITED WARRANTY
NOTE: For details, refer to the warranty statement. Copies of this statement may be obtained by contacting Peavey Electronics Corporation, P.O. Box 2898, Meridian, Mississippi
2