EFFECTS RETURN (7)

Input for returning signals from external low-level effects or signal processing equipment.

NOTE: Signals are supplied to outboard effects or signal processing units by patching from the effects send jack (6) output into the outboard unit(s) and back into the effects return (7) input using shielded cable with l/4” phone plugs. Only non-gain effects devices (chorus, reverb, delay, etc.) should be used in the effects loop.

Remote (on/off) selection of outboard effects devices can be achieved using the footswitch.

PREAMP OUT (8)

The preamp out jack can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect the preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not affect the opera- tion of the amplifier.

IMPEDANCE SELECTOR SWITCH (9)

Use to select the appropriate impedance of the speaker enclosure(s). If two enclosures of equal impedance are used, the switch should be set at one-half of that value (e.g., two 16 ohm enclosures: set switch to 8 ohms; two 8 ohm enclosures: set switch to 4 ohms). When using only the internal speakers, the Impedance Selector Switch should be set to 16 ohm.

SPEAKER OUTPUTS (10)

Paralleled l/4” output jacks for connecting speaker enclosure(s) to the amplifier (minimum 4 ohms). When using more than one enclosure, be sure to calculate the total impedance and set the impedance switch (9) accordingly. (See section on Impedance Switch.)

IMPORTANT: Use only high quality, unshielded cable for speaker connections.

SPECIFICATIONS

THIS BLOCK DIAGRAM

 

 

 

 

 

 

 

 

PRE

 

POST

SHOWS SIGNAL FLOW

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

L PUSH

 

WITHIN THE UNIT. IN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INPUTS

 

 

 

 

 

 

 

f

BOOST

 

ORDER TO THOROUGHLY

GAIN

PREAMP L

 

LOGIC /T

HIGH

 

 

 

 

SWITCH

 

 

 

 

LOW

 

 

 

 

 

 

 

-

 

 

 

 

 

UNDERSTAND THE UNIT’S

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GAIN

 

 

 

 

 

 

 

 

 

 

 

 

 

FUNCTIONS, PLEASE

 

 

 

RESONANCE PRESENCE

PUSH LEAD EQ

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

STUDY THE BLOCK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DIAGRAM CAREFULLY.

 

 

 

 

 

 

 

 

 

 

 

 

CLEAN EQ

 

LO MID HI

I

1 I”‘““”

MASTER

LEVEL

PREAMP

OU T -

P

-

6

Page 6
Image 6
Peavey Duel 212 manual Effects Return, Preamp OUT, Impedance Selector Switch, Speaker Outputs