Peavey JSX Mini Colossal manual Rear Panel

Rear Panel

10 11 12 13 14 15

10IEC MAINS CONNECTOR

This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. The mains cord should be connected to the amplifier before connecting to a suitable AC outlet.

U.S. DOMESTIC AC MAINS CORD

The mains cord supplied with the unit is a heavy-duty, 3-conductor type with a conventional 120 VAC plug with ground pin. If the outlet used does not have a ground pin, a suitable grounding adapter should be used, and the third wire should be grounded properly.

Never break off the ground pin on any equipment. It is provided for your safety.

NOTE: FOR U.K. ONLY

If the colors of the wires in the mains lead of this unit do not correspond with the colored markings iden- tifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green, or colored green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L or colored red.

11POWER SPONGE™

This unique control allows the user to adjust the nominal output power level of the amplifier. It can be used in conjunction with the VOLUME (2) control to attain infinite combinations of power amp and pre- amp distortion at any volume level. This control DOES NOT affect the level of the Microphone Simulated Recording output and provides an appropriate load to the amplifier at all settings.

12SPEAKER OUTPUTS

These paralleled 1/4" mono (TS) jacks are provided for the connection of speaker enclosure(s). Mini- mum speaker impedance is 4 Ohms. The CABINET IMPEDANCE SELECTOR switch (13) must be set to match the load of the speaker cabinet(s). The internal speaker is 8 Ohms.

13CABINET IMPEDANCE SELECTOR

This three-position switch allows for appropriate selection of speaker cabinet impedance. If two enclo- sures of equal impedance are used, the switch should be set to half the individual value. For example, two 16 Ohm enclosures necessitate an 8 Ohm setting, while two 8 Ohm enclosures would require a 4 Ohm setting. Minimum speaker impedance is 4 Ohms.

14GROUND LIFT

Depress this switch to break any ground loops that may be causing hum between your amplifier and recording device or PA system.

15RECORDING OUT

This XLR jack is used to route a Microphone Simulated signal (tapped directly from the speaker being used) from the amplifier to an external recording device or public address system. It utilizes a 100% passive circuit to avoid clipping, noise, and other shortcomings of solid-state circuitry.