on indicates that the battery is either dead or
not installed. Aconstant glow indicates a weak
batter that should be replaced.
5. On-Of switch. Push forward to turn the
transmitter on and slide back to turn the
transmitter off. RF signal is transmitted almost
immediately the switch is turned on (and the
corresponding RF present lamp will glow on
the receiver), setting the receiver in to ‘stand
by’ mode. AF signal is only transmitted when a
RF link is active and the microphone threshold
is opened, i.e. by speech.
6. Group and channel selector cover: push this
cover down and back as indicated to access
the group and channel selector switches.
7. Group selector switch: make sure this setting
matches the group selection on the receiver.
(Under group and channel selector cover.)
8. Channel selector switch: make sure this
setting matches the channel selection on the
receiver. (Under group and channel selector
cover.)
9. Unavailable setting indicator. This led glows
(when the transmitter has been powered on) if
you select a switch combination that has no
connection. (Under group and channel
selector cover..)
15