Peavey PV1600 Front Panel, 1INPUT GAIN dB, 2POWER LEDs PWR, 3SIGNAL ACTIVITY LEDs, 5POWER SWITCH

Front Panel

4

3

2

1

5

1INPUT GAIN (dB)

The low and high channels of this amp each have individual Input Sensitivity controls. Normally these controls should be set the same but may be adjusted as needed in each situation. The setting controls the amount of signal necessary to drive the amplifier, not the output of the amplifier. A higher setting will result in more system headroom while a lower setting will result in lower system noise.

2POWER LEDs (PWR)

These indicators illuminate when the AC mains power is being supplied to the amp and both High and Low channels are operational. If either channel experiences fault conditions, exceeds safe operating temperature limits, or if the mains circuit breaker trips, both channel power LEDs will be dark, indicating shutdown.

3SIGNAL ACTIVITY LEDs

These indicators illuminate when the associated channel output signal level exceeds 1 V RMS.

4DDT® ACTIVE LEDs

These indicators illuminate when DDT compression is taking place in the associated channel.

5POWER SWITCH

This heavy-duty, rocker-type switch turns on the mains power to the amplifier. When the mains power is applied, there is a three-second delay in activation of the unit. This reduces/eliminates the turn-on transients associated with connected system equipment and protects loudspeakers.