Peavey PV215EQ F R O N T Pa N E L, Level Led Meter, Level Control, Equalizer Section, Bypass

F R O N T PA N E L

3

6

3

54

2

1

LEVEL LED METER (1)

This LED array indicates level from –12 dB to +17 dB.

LEVEL CONTROL (2)

This control regulates overall level of the EQUALIZER SECTION.

Unity gain throughout the signal chain can be maintained by recovering lost signal gain at this point. The equalization process may result in noticeable signal loss.To compensate for this loss, engage the BYPASS switch (5) and compare the signal level with that of the equalized level. Increase the LEVEL control until the equalized level approximates that of the bypassed level. Let your ears be your guide.

EQUALIZER SECTION (3)

These calibrated, detented controls adjust the amount of cut or boost at their respective frequencies.They

are adjustable from -12 dB (cut) to +12 dB (boost).

LOW-CUT FILTER (4)

This switch activates the low-cut filter that rejects frequencies below 40 Hz. Frequency roll-off is 18 dB per octave with the switch engaged.This filter will operate even with the BYPASS (5) switch engaged.The adjacent red LED indicates activation.

BYPASS (5)

This switch allows the signal to bypass all features except the LOW-CUT FILTER (4).When this switch is engaged, the signal is routed from INPUT (10 and 11) though the low-cut filter to the channel's output. Bypass is indicated by the illumination of the LED located above the switch.

POWER (6)

This 2-position rocker switch applies mains power to the unit when in the ON position.The adjacent red LED indicates mains power activation.

WARNING

THE ON/OFF SWITCH IN THIS APPARATUS

DOES NOT BREAK BOTH SIDES OF THE MAINS.

HAZARDOUS ENERGY MAY BE PRESENT INSIDE

THE ENCLOSURE WHEN THE POWER SWITCH IS

IN THE OFF POSITION.