Peavey PV 231EQ Level LED Meter, Level Control, Variable LOW-CUT Filter, Variable HIGH-CUT Filter

F R O N T PA N E L

5

5

LEVEL LED METER (1)

This LED array indicates level from –10 dB to +17 dB.

LEVEL CONTROL (2)

7

1 6 3 4 2

1 6 3 4 2 8

7

This calibrated, detented control regulates overall gain of the EQUALIZER SECTION (5). Unity gain throughout the signal chain can be maintained by recovering lost signal gain at this point.The equalization process may result in noticeable signal loss.To compensate for this loss, engage the BYPASS (6) switch and compare the signal level with that of the equalized level. Increase the GAIN control until the equalized level approximates that of the bypassed level. Let your ears be your guide.

VARIABLE LOW-CUT FILTER (3)

This control adjusts the variable-state low-cut filter that rejects frequencies below the point selected. Frequency roll-off is 18 dB per octave.This filter will operate even with the BYPASS (6) switch engaged.

VARIABLE HIGH-CUT FILTER (4)

This control adjusts the variable-state high-cut filter that rejects frequencies above the point selected. Frequency roll off is 18 dB per octave.This filter will operate even with the BYPASS (6) switch engaged.

EQUALIZER SECTION (5)

These calibrated, detented controls adjust the amount of cut or boost at their respective frequencies.They are adjustable from -12 dB (cut) to +12 dB (boost) or -6 dB (cut) to 6 dB (boost) depending on the position of the Range switch.

BYPASS (6)

This switch allows the signal to bypass all features except the LOW-CUT FILTER (4).When this switch is engaged, the signal is routed from INPUT (10 and 11) though the low-cut filter to the channel’s output. Bypass is indicated by illumination of LED above the switch.

RANGE (7)

This switch allows the selection of range (+/-12 dB or +/-6 dB) of the Equalizer Section controls.This gives
the operator the ability of finer control of the equalization.
POWER (8)	WARNING
	THE ON/OFF SWITCH IN THIS APPARATUS
This 2-position rocker switch applies mains power to the unit	DOES NOT BREAK BOTH SIDES OF THE MAINS.
when in the ON position.The adjacent red LED indicates	HAZARDOUS ENERGY MAY BE PRESENT INSIDE
mains power activation.	THE ENCLOSURE WHEN THE POWER SWITCH IS
	IN THE OFF POSITION.

8