Peavey PV Series manual Specifications

Specifications	PV® 900	PV® 1500	PV® 2600
RATED OUTPUT POWER:
Stereo mode (EIA both channels driven)
4 Ohms EIA, 1 kHz, 1% THD	300 W RMS/chan	500 W RMS/chan	900 W RMS/chan
8 Ohms EIA, 1 kHz, 1% THD	180 W RMS/chan	300 W RMS/chan	550 W RMS/chan
Bridge mode, mono
8 Ohms EIA, 1 kHz, 1% THD	600 W RMS	1000 W RMS	1800 W RMS
HUM & NOISE:
Stereo mode, below rated output power, 4 ohms	100 dB, unweighted	100 dB, unweighted	100 dB, unweighted
DISTORTION:

SMPTE-IM

INPUT SENSITIVITY & IMPEDANCE:

@rated output power, 4 ohms Balanced, TRS 1/4” phone jack Balanced, XLR (pin 2 positive)

Overall system gain per channel

DISTORTION: (THD, typical value)

Stereo mode, both channels driven, 4 Ohms 20 Hz to 20 kHz, 10 dB below rated power 20 Hz to 2 kHz, at full rated power

FREQUENCY RESPONSE:

Stereo mode, both channels driven +0, -1 dB @ 1 W RMS, 4 ohms +0, -3 dB @ rated output, 4 ohms

DAMPING FACTOR: (Typical value) Stereo mode, both channels driven

8 Ohms, 1 kHz

POWER CONSUMPTION:

Stereo mode, both channels driven @ 1/8 rated output power, 4 Ohms

TOPOLOGY:

WEIGHT:

FEATURE SET:

DDT™ COMPRESSION ++:

COOLING SYSTEM:

LOW CUT FILTER ++: CROSSOVER ++: INPUTS ++:

CROSSOVER OUTPUTS ++: AMPLIFIER OUTPUTS: LED INDICATORS ++:

AMP PROTECTION:

LOAD PROTECTION:

MAINS VOLTAGES AVAILABLE DIMENSIONS:

Less than 0.01%		Less than 0.01%		Less than 0.01%
0.87 V RMS(-1.2 dBV)		1.12 V RMS(+1dBV)		1.5 V RMS(+3.5 dBV)
10	K Ohms per leg	10	K Ohms per leg	10	K Ohms per leg
10	K Ohms per leg	10	K Ohms per leg	10	K Ohms per leg
40X (+32 dB)		40X (+32 dB)		40X (+32 dB)
Less than 0.03%		Less than 0.03%		Less than 0.03%
Less than 0.03%		Less than 0.03%		Less than 0.03%
20	Hz to 20 kHz	20	Hz to 20 kHz	20	Hz to 20 kHz
5 Hz to 50 kHz		5 Hz to 50 kHz		5 Hz to 50 kHz
Greater than 300		Greater than 300		Greater than 300
5.0 ARMS @ 120 VAC		7.0 ARMS @ 120 VAC		7.0 ARMS @ 120 VAC
Class AB		Class AB		Class H
40 lbs (18.2 kg)		45 lbs (20.5 kg)		49 lbs (22.3 kg)

All Models (++ indicates each channel)

Automatic, switchable with LED indicator Two-speed DC fan, air flow back to front -3 dB @ 40 Hz, 12 dB per octave

150 Hz, 4-pole Linkwitz-Riley approximation

Electronic balanced; Barrier Strip, XLR, TRS 1/4" (6.3 mm) Low/Thru and High, TS 1/4" (6.3 mm)

Speakons for Chan A, Chan B and Bridge; Binding Posts Red, DDT/clipping; Yellow, signal; Green, power

Full short circuit, open circuit; over-temp thermal; RF; stable into any load Turn on/off muting, DC (triac crowbar), low-cut filter

100, 120, 230, 240 VAC, 50-60 Hz

Height: 3.5” (8.9 cm), Width: 19" (48.3 cm), Depth: 15.5" (38.0 cm)

Specifications subject to change without notice

12