Peavey PVTMi 8B Master Level, Effects Volume, Effects Echo, Effects Delay, Tape/Cd Volume, Power

Front Panel

7

8

14

9

11

12

13

15

10

Features

(7) MASTER LEVEL

This controls the overall volume level of the entire amplifier. Typical operation is between 4 and 8.

(8) EFFECTS VOLUME

This controls the level of the echo and delay that is added back to the master mix.

(9) EFFECTS ECHO

This controls the character of the Reverb that is added back to the master mix. This is analogous with changing the rate at which the echo decays.

(10) EFFECTS DELAY

This controls the delay of the Reverb that is added back to the master mix. Increase this control to simulate the effect of larger rooms.

(11) TAPE/CD VOLUME

This controls the level of the playback inputs (RCA jacks).

(12) TAPE IN (L/R)

These RCA jacks are for connecting a cassette deck, CD player or other line-level source.

(13) TAPE OUT (L/R)

These RCA output jacks are primarily intended for connecting a tape deck, MP3 player, or other device for the purpose of recording from the mixer. Both channels are summed into mono for compatibility. The signals are taken pre-master section, meaning that they are without reverb or the master tone section, and do not include the Tape-In signal. If you wish to record with reverb and the Tape-In signals, use the 1/4" line output (2) with the proper cable.

(14) MASTER EQ

These are used to adjust the overall EQ of the master mix. Since these cover five frequency bands (+/-15 dB), they will add or diminish the level of the sound at the indicated frequencies, spread across approximately one octave of frequency range. Most situations should require using no more than three controls simultaneously. Do not boost or cut all five at the same time. Excessive boosting will increase the probability of feedback.

(15) POWER

This switches the unit on or off. When the unit is powered ON, the front-panel blue LED will illuminate.

WARNING

THE ON/OFF SWITCH IN THIS APPARATUS

DOES NOT BREAK BOTH SIDES OF THE MAINS.

HAZARDOUS ENERGY MAY BE PRESENT INSIDE

THE ENCLOSURE WHEN THE POWER SWITCH IS

IN THE OFF POSITION.