Peavey XR 8600 Rated Power DDT Dynamic Range Input Impedance, Hum and Noise, Dimensions WxHxD

			XR® 8300 & XR® 8600 Specifications
Hum and Noise
	Output	Residual Noise	Test Conditions
		Ref: 4dBu
	Main	-102dB	All controls down
		-90dB	1 channel nominal, Master nominal
			All controls down
	Monitor	-98dB	1 channel nominal, Master nominal
		-90dB	Master Fader Nominal, Channel Fades Nominal, Mic Inputs Terminated @ 150 ohms

Hum and Noise measurements: 22Hz-22kHz BW

S/N Ratio:

>90dB below rated power output, Mic/Line to Speaker Output

Equivalent Input Noise (EIN)

-122dBu (Input terminated with 150 ohms)

Crosstalk

>80dB Adjacent Input Channels (20Hz-20kHz) >70dB Left to Right Outputs (20Hz-20kHz)

Common Mode Rejection Ratio (Mic Input)

50dB minimum (20Hz-20kHz) 60dB typical @ 1kHz

XR 8300 - Power Amplifier Specifications

Power Section:	Total Harmonic Distortion (THD)	Input Sensitivity:
400 SC Module with DDT	<0.02% @ rated output @ 1kHz	1.225 V RMS for rated power output
Rated Power:	DDT Dynamic Range:	Input Impedance:
300W program into 4 ohms, both	Greater than 26dB	11k ohms
channels driven/210W RMS into 4	DDT Maximum Distortion:	Power Requirements:
ohms, both channels driven.	Below 0.5% THD for 6dB overload	DOM: 120VAC 60Hz 360W nominal
215W program into 8 ohms, both	Below 1% THD for 20dB overload	EXP: 220-230VAC/240VAC 50/60Hz
channels driven/150W RMS into 8		360W nominal
ohms, both channels driven.	Hum and Noise:
	95dB below rated power level	Dimensions (WxHxD):
Frequency Response:	(300W)	19.125" x 10.875" x 11"
20Hz-20kHz +0dB/-1dB @ rated
power	Damping Factor:	Weight:
	Greater than 100 @ 1kHz, 4 ohms	35.6 lbs

16