Visit the Peerless Web Site at www.peerlessmounts.com
ISSUED: 09-04-08 SHEET #: 090-9150-3 10-05-09
For customer care call 1-800-729-0307 or 708-865-8870.
NOTE: Display base stand may appear different than illustrated.
6 of 6
DESK SURFACE
DRIED 3M RUBBER AND VINYL #80 SPRAY ADHESIVE (not supplied)
DISPLAY BASE STAND
NOTE: After application of tape on lock-down plate (A), the bond strength will increase as the adhesive flows onto the surface.
At room tempurature, approximately 50% of the ultimate strength will be achieved after 20 minutes, 90% after 24 hours,
and 100% after 72 hours. In some cases, bond strength can be achieved more quickly
by exposure to elevated temperatures (e.g. 150°F [66°C] for 1 hour).
Clean desk surface with rubbing alcohol. Use 3M rubber and vinyl #80 spray adhesive (not supplied) on the mounting surface area only. NOTE: Spray adhesive will not remove easily. Wait at least 4 minutes to dry before removing tape backing from lock-down plate (A) and placing firmly on surface. NOTE: There is a recommended 72 hour cure time for tape on lock-down plate (A).
NOTE: Once tape backing is removed be careful not to touch the sticky surface of the tape with fingers, as this can cause the tape to lose some of its holding power.
A
E
DRIED 3M RUBBER AND VINYL #80 SPRAY ADHESIVE
CLEAN WITH RUBBING ALCOHOL
4 Clean bottom of lock-down plate (A) with rubbing alcohol. Spray bottom of lock-down plate (A) only where tape will be applied, with 3M rubber and vinyl #80 spray adhesive. Pull apart the four adhesive strips (E) and remove red backing film on both sides. Wait at least 4 minutes to dry before applying adhesive strip (E). Attach adhesive strips (E) firmly to bottom of lock-down plate (A) as shown below.
