Peerless Industries PRS-UNV manual Tools Needed for Assembly, Table of Contents, Wall Construction

Models: PRS-UNV PRS-UNV-S PRS-UNV-W

1 12
Download 12 pages 46.63 Kb
Page 2
Image 2
WALL CONSTRUCTION

Note: Read entire instruction sheet before you start installation and assembly.

HARDWARE REQUIREDWARNING

Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Peerless customer care at

1-800-865-2112, for all international customers, please contact your local distributor.

This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.

Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

Never exceed the Maximum UL Load Capacity. See page one.

If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud fi nder is highly recommended.

Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.

This product was designed to be installed on the following wall construction only;

WALL CONSTRUCTION

HARDWARE REQUIRED

• Wood Stud

Included

• Wood Beam

Included

Solid Concrete

Included

Metal Stud

Contact Qualifi ed Professional (Not Evaluated By UL)

Brick

Contact Qualifi ed Professional (Not Evaluated By UL)

Other or unsure?

Contact Customer Service

Tools Needed for Assembly

stud fi nder ("edge to edge" stud fi nder is recommended)

phillips screwdriver

drill

5/16" bit for concrete surface

5/32" bit for wood studs

level

Table of Contents

 

Parts List

3

Installation to Extension Columns / Ceiling Plate

4

Installation to Wood Joist Ceilings

5

Installation to Concrete Ceilings

6

Installation to Threaded Rods

7

Attaching Adapter Plate to Projector

8

Projector Alignment

10

Accessories

11, 12

2 of 12

ISSUED: 09-19-05 SHEET #: 055-9441-10 06-04-11

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

Page 2
Image 2
Peerless Industries PRS-UNV-S manual Tools Needed for Assembly, Table of Contents, Wall Construction, Hardware Required