Peerless Industries PRS-UNV-S, PRS-UNV-W G, H, I or J, Attaching Adapter Plate to Projector

Models: PRS-UNV PRS-UNV-S PRS-UNV-W

1 12
Download 12 pages 46.63 Kb
Page 8
Image 8
Attaching Adapter Plate to Projector

Attaching Adapter Plate to Projector

Note: The projector you are installing may differ in appearance from the sample illustrated below.

Place projector upside down. Locate adapter plate (B) with notch facing forward as close to projector center of

5 gravity as possible without covering any mounting holes. Loosen channels with 4 mm security t-wrench (L), and if there are only three mounting holes remove fourth channel. Using one channel for each mounting hole, posi- tion feet of channels over mounting holes as shown below. Important: If projector does not have at least three mounting holes, do not use this adapter plate.

Note: Some projectors have feet which can be removed and the corresponding threaded insert can be used for a mounting hole.

Note: Once channels are in position retighten fasteners.

*Notch indicates front of projector.

CHANNEL

FOOT OF CHANNEL

MOUNTING HOLE

B

*

GENERIC PROJECTOR

Attach adapter plate (B) to projector using one screw (G, H, I or J) for each channel as shown below. Tighten all

6 screws, while keeping the center of gravity. Be sure that adapter plate (B) is straight. Adjust the feet of the chan- nels to keep the adapter plate level. Tighten all screws with 4 mm security t-wrench (L) while keeping the center of gravity. If M3 screws (G) are used, tighten using 2 mm security allen wrench (M).

Note: Projectors will require different size screws for mounting. Use a combination of screws (G, H, I or J) and

foot adjustment that will result in channels of adapter plate (B) fi tting tightly against projector. Important: In order to properly engage the threads in the mounting holes, the screw must be turned at least 3 full turns.

Note: If using screw (G), place washer (K) between screw (G) and foot of channel.

CAUTION

It is the responsibility of the installer to ensure that the projector is properly ventilated. Feet of channels are used to raise the mount off the projector surface.

B

G, H, I or JG, H, I or J

FOOT OF CHANNEL

8 of 12

ISSUED: 09-19-05 SHEET #: 055-9441-10 06-04-11

Visit the Peerless Web Site at www.peerlessmounts.com

For customer care call 1-800-865-2112 or 708-865-8870.

Page 8
Image 8
Peerless Industries PRS-UNV-S, PRS-UNV-W manual G, H, I or J, Attaching Adapter Plate to Projector