Mounting and Removing Flat Panel Screen
WARNING
•Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel screen.
•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.
•Be careful not to pinch fingers when pushing screen from the bottom.
3 | Tension Adjustment of Ratchet Handle: Adjust |
tension in tilt brackets (BB & CC) by rotating |
ratchet handle. NOTE: If obstruction prevents ratchet handle from rotating, pull handle out while turning will allow handle to reposition without tightening. Release and turn handle to tighten or loosen.
Mounting Screen: Ratchet handle must be in the up or down position or interference will occur while hooking tilt brackets to wall plate (AA). Slowly hook tilt brackets (BB & CC) onto wall plate (AA) and swing screen down as shown in fig. 3.1. Tilt bracket hooks must fully engage wall plate as shown in detail 1. Using phillips screw driver, turn safety screws on tilt brackets (BB & CC) clockwise till screw tip securely contacts wall plate as shown in cross section.
Screen Adjustment: Screen can be adjusted horizontally by loosening safety screws on tilt brackets (BB & CC) three full turns with phillips screw driver. Adjust screen as shown in fig. 3.2. Tighten safety screws on tilt brackets till screw tip securely contacts wall plate as shown in cross section.
Removing Screen: To remove screen from mount, loosen safety screws, swing screen away from mount, and lift screen off of mount.
BB &
CC
AA |
|
DETAIL 1 | |
| RATCHET |
AA | HANDLE |
| |
SAFETY | BB & |
SCREW | |
| CC |
CROSS SECTION
fig 3.1
fig 3.2
Adjusting the Tilt Angle of the Flat Panel Screen
4 | For preset tilt angles use Increlok™ and for |
custom tilt angle use ratchet handle. |
INCRELOK™: The screen can be locked into a
Ratchet Handle: Loosen ratchet handle (refer to step 3 for tension adjustment of handle). Push or pull from top or bottom of screen to adjust tilt as shown in fig. 4.1. The tilt can be adjusted to a maximum of 15° forward or 5° backward.
IncreLok™ |
| |
TILT LOCKING | LOCATOR | |
SCREW | ||
HOLE | ||
|
TILT | RATCHET |
POSITION | HANDLE |
HOLES | DETAIL 2 |
fig 4.1 
8 of 24
Visit Peerless website at www.peerlessmounts.com
ISSUED:
For customer care call
© 2007, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.
