4 of 34 ISSUED: 02-05-09 SHEET #: 202-9272-4 04-12-10
Installation to Double Wood Stud Wall
Use a stud fi nder to locate the edges of the studs. Use of an edge-to-edge stud fi nder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center. Place wall plate on wall as a template. The top
mounting slots should be 2.5" (64 mm) above the desired screen center as shown in fi gure 1.1. Level plate, and
mark the center of the four mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill four
5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the wall plate is level, secure it using four #14 x 2.5"
wood screws (DD) as shown in fi gure 1.2.
NOTE: Wall plate may be mounted up to 4" (102 mm) off center as shown in fi gure 1.1.
Skip to step 2.
fi g. 1.1
CS = center of screen
DD
4"
(102 mm)
CS
4"
(102 mm)
STUD
AA
2.5"
(64 mm)
fi g. 1.2
AA
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations (not UL approved).
WARNING
1