Peerless Industries PT660, PWS421 manual Adjusting the Tilt Angle of the Flat Panel, Screen

Mounting and Removing Flat Panel Screen

WARNING

•Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel screen.

•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.

•Be careful not to pinch fingers when pushing screen from the bottom.

3	Tension Adjustment of Ratchet Handle: Adjust
	tension in tilt brackets (BB & CC) by rotating

ratchet handle. NOTE: If obstruction prevents ratchet handle from rotating, pull handle out while turning will allow handle to reposition without tightening. Release and turn handle to tighten or loosen.

BB&

CC

AA	DETAIL 1
	RATCHET
AA	HANDLE

SAFETY	BB &
SCREW
	CC

Mounting Screen: Ratchet handle must be in the up or down position or interference will occur while hooking tilt brackets to wall plate (AA). Slowly hook tilt brackets (BB & CC) onto wall plate (AA) and swing screen down as shown in fig. 3.1. Tilt bracket hooks must fully engage wall plate as shown in detail 1. Using phillips screw driver, turn safety screws on tilt brackets (BB & CC) clockwise till screw tip securely contacts wall plate as shown in cross section.

Screen Adjustment: Screen can be adjusted horizontally by loosening safety screws on tilt brackets (BB & CC) three full turns with phillips screw driver. Adjust screen as shown in fig. 3.2. Tighten safety screws on tilt brackets till screw tip securely contacts wall plate as shown in cross section.

Removing Screen: To remove screen from mount, loosen safety screws, swing screen away from mount, and lift screen off of mount.

CROSS SECTION fig 3.1

fig 3.2

Adjusting the Tilt Angle of the Flat Panel			IncreLok™ TILT
			LOCKING SCREW
Screen			LOCATOR
4	For preset tilt angles use Increlok™ and for		HOLE
	custom tilt angle use ratchet handle.
	INCRELOK™: The screen can be locked into a
	pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
	locator hole to find tilt position hole and tilt screen	TILT	RATCHET
	to align holes. Tighten IncreLok™ tilt locking	POSITION	HANDLE
	screws on both tilt brackets to lock tilt as shown in	HOLES	DETAIL 2
	detail 2.

Ratchet Handle: Loosen ratchet handle (refer
to step 3 for tension adjustment of handle). Push
or pull from top or bottom of screen to adjust tilt	fig 4.1
as shown in fig. 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
8 of 34	ISSUED: 02-05-09 SHEET #: 202-9272-4 04-12-10

© 2009, Peerless Industries, Inc. All rights reserved. All other brand and product names are trademarks or registered trademarks of their respective owners.

Peerless Industries, Inc.

3215 W. North Ave. Melrose Park, IL 60160 www.peerlessmounts.com