EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE
REFERENCE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD PUT THE CHILD’S SAFETY AT RISK.
_THIS PRODUCT IS DESIGNED FOR CHILDREN WHOSE MAXIMUM WEIGHT IS 45 POUNDS (20 KG) AND WHOSE MAXIMUM HEIGHT IS 43 INCHES (110 CM). THIS SHOPPER BASKET IS DESIGNED TO CARRY A MAXIMUM WEIGHT OF 11 POUNDS (5 KG). ANY CUPHOLDER EVENTUALLY PROVIDED WITH THIS UNIT IS DESIGNED TO CARRY A MAXIMUM WEIGHT SPECIFIED ON THE CUPHOLDER ITSELF. ANY POACH OR
POCKET PROVIDED WITH THIS UNIT IS DESIGNED TO CARRY A MAXIMUM WEIGHT OF 0.44 POUNDS (0.2 KG).
_FAILURE TO FOLLOW MANUFACTURER’S SPECIFICATIONS OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE MANUFACTURER MAY CAUSE THE UNIT TO BECOME UNSTABLE.
_AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT. ALWAYS USE COMPLETE 5 POINT SEAT BELT.
_NEVER LEAVE YOUR CHILD UNATTENDED.
_ALWAYS USE ALL THE BRAKES WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN MAKING ADJUSTMENTS ENSURE THE CHILD’S BODY IS CLEAR OF ALL MOVING PARTS.
_ ALL OPERATING AND ASSEMBLY PROCEDURES SHOULD BE PERFORMED BY AN ADULT.
_DO NOT LIFT THE STROLLER BY GRIPPING THE FRONT BAR. THE FRONT BAR IS NOT DESIGNED TO
WITHSTAND LOADS.
_ENSURE THAT THE STROLLER IS OPENED CORRECTLY AND LOCKED IN POSITION OF USE.
_CHECK TO MAKE SURE THAT THE CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE STROLLER (WHERE APPLICABLE).
_DO NOT DRIVE THIS PRODUCT AROUND STAIRS OR STEPS; CARE MUST BE TAKEN IF UNIT IS USED ON STAIRS OR ESCALATORS.
_DO NOT USE THE PRODUCT IF IT HAS BROKEN OR MISSING PARTS.
_DO NOT USE NEAR FIRE OR EXPOSED FLAME.
_NOTICE: THIS ARTICLE MEETS OR EXCEEDS ALL REQUIREMENTS COVERED IN ASTM F833 STANDARD AND LATEST REVISIONS.
INSTRUCTIONS
1OPENING: to open the stroller, simultaneously release the two fasteners (fig_a) and firmly lift
the handlebar (fig_b), before pushing it down until the final click (fig_c).
2FRONT
3HOODS: the hoods are independent. One or both may be lowered at any one time. Insert the hood clips into the appropriate housing (fig_a), button the hoods to the rear of the
backrests (fig_b) and open by pulling forward (fig_c). To remove the hoods, push the side buttons and simultaneously slip the hood upwards (fig_d).
4
5BRAKE: Press down on the brake lever situated on the rear wheel unit to set the
brake on the stroller. Lift the lever to release the brake. Always set the brake when the stroller is at a standstill.
6
- 11 -