Pelco 300 manual Installation, Desktop Stand, Rear Panel Connectors

Installation

The monitor can be placed on any flat surface (desk or table), or it can be rack mounted or wall mounted.

NOTE: Only use a recommended rack mount kit such as the PMCL-RM15, PMCL-RM17, PMCL-RM19, or PMCL-WM. To rack-mount the monitor, follow the instructions supplied with the rack mount kit, or wall mount kit.

DESKTOP STAND

You can manually adjust the 300 Series monitor to the viewing angle you want by repositioning the foot stand on the back of the monitor.

REAR PANEL CONNECTORS

￿

￿

￿

￿

￿ ￿ ￿ ￿

Figure 2. Rear Panel Connectors

1.AC IN: Can be connected to a 100-240 VAC, 50/60 Hz source.

2.VGA: Can be connected to the VGA cable (supplied).

3.S-VIDEO IN: Connection can input an S-Video signal by DIN socket.

4.S-VIDEO OUT: Can output an S-Video signal by DIN socket. This socket is the loop-through output (maximum of one looping operation only recommended).

5.AUDIO IN: These RCA sockets can input sound from an audio source.

6.VIDEO 1 IN/OUT: The IN BNC socket can be connected to composite video output. The OUT BNC socket is the loop-through output with auto-termination from above video inputs.

7.Speakers: The unit has two built-in speakers.

C2926M-C (5/07) 7