Pelco BB08 - page 12

12 Pelco Manual C456M-D (1/98)

13. If you are not using Coaxitron® control, connect the control wiring to RXD+

and RXD-.

From controller To 4-wire terminal inside back box

TXD+ RXD+

TXD- RXD-

14. The bezel and dome assembly can be attached to the back box at this time, or

it can be done after the dome drive is installed.

To install the dome drive, refer to the manual provided with the dome drive.

To attach the bezel and dome assembly to the back box, clip the safety cable

inside the bezel to the bracket just below the power switch inside the back box.

Let the bezel and dome assembly hang from the back box until the dome drive

is installed.

15. The back box installation is now complete. Proceed with the installation of the

dome drive unit. Refer to the manual provided with the dome drive for further

installation instructions.

Contents

Main CONTENTS REVISION HISTORY LIST OF ILLUSTRATIONS LIST OF TABLES Pelco Manual C456M-D (1/98) 3 1.0 GENERAL 1.1 IMPORTANT SAFEGUARDS AND WARNINGS The product and/or manual may bear the following marks: 4Pelco Manual C456M-D (1/98) 1.2 UNPACKING INSTRUCTIONS 1.3 RECOMMENDED TOOLS Pelco Manual C456M-D (1/98) 5 2.0 DESCRIPTION 2.1 MODELS 6Pelco Manual C456M-D (1/98) 3.0 INSTALLATION 3.1 SUSPENDED CEILING Table A. Video Coaxial Cable Requirements Wire Gauge NOTE: EXAMPLE: Table B. 24 VAC Wiring Distances 8Pelco Manual C456M-D (1/98) Figure 1. T-Bar Clip Installation Page Page Pelco Manual C456M-D (1/98) 11 3.2 PENDANT NOTE: Page Figure 4. BB08A120 Back Box Exploded Assembly Diagram 4.0 EXPLODED ASSEMBLY DIAGRAMS Page Table C. BB08A120 Back Box Exploded Assembly Parts List (Figure 4) Table D. BB08E120 and BB08E211 Back Boxes Exploded Assembly Parts List (Figure 5) Page Table E. Back Plate Exploded Assembly Parts List 5.0 SPECIFICATIONS (Design and product specifications subject to change without notice.) Page 6.0 WARRANTY AND RETURN INFORMATION WARRANTY RETURNS