Pelco C1302M-F (11/08) - page 19

C1302M-F (11/08) 19
3. For models with wipers, also remove the wiper arm and the green bushing from the unit (see Figure 13).
4. Slide the camera module out of the enclosure.
5. Install the new camera module by doing the following:
Slide the camera module into the enclosure. Refer to Figure14 to position the camera module properly in the enclosure. Carefully mate the
camera’s power connector to the mating connector located inside the enclosure.
Models with a wiper: The tab located inside the enclosure must be pointing down before installing the camera module (refer to
Figure14). To position the tab, place the wiper located at the f ront of the enclosure in the center of the viewing window (refer to Figure15).
Figure 14. Install Camera Module
Figure 15. Center Wiper
WARNING: Never force the camera module into the enclosure.
CENTER
NOTCHES
TAB
CAMERA
MODULE
CAMERA
ENCLOSURE
CENTER WIPER