C1510M-QS – CM9760-SAT Quick Start Reference Guide
–6–
COMBINED LOCAL AND SYSTEM
Here, you need to pay close attention to the specific monitor-out line you are setting menu attributes for. For all monitor-outs connected to a
LOCAL monitor, assign Monitor menu attributes just as they were listed and discussed under LOCAL ONLY.
For all monitor-outs configured as a TIE LINE, assign Monitor menu attributes just as they were listed and discussed under SYSTEM ONLY.
The difference between LOCAL ONLY and SYSTEM ONLY as opposed to COMBINED or shared alarm implementation appears when the menu
attributes in the Contact menu of the SAT ALARM file are assigned. It is here that we accommodate both LOCAL and SYSTEM alarm activation
at the same time. This can best be seen in a side-by-side comparison of the menus for the three states of alarm activation.
To complete alarm implementation for the combined
example, you must carry through the System Alarm
portion of the menu settings in the same manner that
was done for System Alarm Only. That is, configure the
9760 CC1 configuration menus (System, Comms, and
Alarm files), just as they were listed and discussed
under SYSTEM ONLY.