Pelco C1620M-B (9/05) CONNECTING THE KEYBOARD, , TURNING ON THE POWER

10 C1620M-B (9/05)

CONNECTING THE KEYBOARD

To hook up the KBD5000, connect the USB Type B-to-Type A cable (supplied) from the USB connector on the rear of the KBD5000 to the USB

connector on either the front or rear of the Pelco VCD5000 virtual console display or to the USB connector on an Endura Workstation (WS5000

Series). (As an example, Figure 6 shows a connection to either the rear or front of a VCD5000.)

NOTE:

Any USB cable attached to the keyboard must be no longer than 16.4 feet (5.0 m).

Figure 6.

Connecting the KBD5000 to a VCD5000 or a WS5050

TURNING ON THE POWER

To apply power, ﬁrst insert the power supply’s attached cord into the back of the keyboard and tighten the connector barrel. Then, insert the

appropriate supplied power cord (USA standard, UK standard, or European standard) into the power supply. Finally, insert the power cord’s plug

into a properly grounded power socket. When power is applied, lights on the modules illuminate.

OR VCD5000 REAR

VCD5000 FRONT (BEZEL OFF)

WS5050 REAR

WS5050 FRONT (BEZEL OFF)

WS5050 REAR