C2410M-I (1/06) 7
MOUNTING TO CEILING TILE
1. Remove the ceiling tile.
2. Using the adapter plate as a
template, cut a hole 3.5
inches (9 cm) in diameter in
the ceiling tile for the back
box. Punch four screw holes
in the ceiling tile.
3. Attach the back box to the
ceiling tile and adapter plate
with the four 8-32 x 1.25-inch
screws (see diagram).
4. Replace the ceiling tile.
5. Remove an adjacent ceiling tile and connect the video cable.
6. Connect the power wires.
• For 12 VDC, connect the 24 VAC/12 VDC (red) and GND (black) wires to input power.
The blue wire is not used.
• For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.
The black wire is not used.
INSTALL CAMERA 1. Some indoor installations do not require a
heater. If the installation does not require a
heater, remove the heater board from the
camera assembly. To remove the heater apply
pressure and press on the corner of the board.
2.
12 VDC Operation
Only
- The camera is
set for 24 VAC
operation at the
factory. For 12 VDC
operation remove the
jumper from the 24
VAC position and
install it on the 12 VDC
position.
WARNING:
Heater elements could be hot! When camera power is on, use caution when
adjusting the camera. This applies to all models.
CEILING TILE
BACK BOX
ADAPTER PLATE
8-32 X 1.25
MOUNTING
HARDWARE
(SUPPLIED)
MOUNTING TO CEILING TILE
HEATER
BOARD
24 VAC JUMPER
12 VDC JUMPER
VIDEO
CONNECTOR
HEATER
CONNECTOR