Pelco C2410M-1 , Adjustments (Color Camera Only)

C2410M-I (1/06) 9

Place the trim ring and dome over the back box. If the

dome has a liner, position the viewing window over

the lens of the camera. Tighten the tamper-resistant

screws with the supplied 1/8-inch hollow screwdriver

bit. Note that the screws are installed at an angle.

Adjustments (Color Camera Only)

If you have a color camera, it is set up at the factory and normally requires no adjustments.

Sometimes, however, adjustments may be necessary.

1. Remove the dome and trim ring using the supplied 1/8-inch hollow screwdriver bit.

2. Adjust the vertical phase, iris level, focus, or switch settings (refer to procedures below).

3. Replace the dome and trim ring.

Adjustment is required if there is vertical roll when switching between two cameras.

1. Reverse the 24 VAC connections on one camera. If both cameras are connected to the same

transformer, this should solve the problem.

2. If reversing the connections does not solve the problem, or if cameras are connected to

different transformers, turn the adjustment screw on one camera (while switching as rapidly

as possible between the two camera views) until the switching is clean and there is no

vertical roll. If more than two cameras are out of synchronization with each other, choose one

camera and synchronize all others to it.

VERTICAL

PHASE

ADJUSTMENT

FIXED LENS

VERTICAL PHASE

ADJUSTMENT

VARIFOCAL LENS