MOUNTING TO CEILING TILE
ADAPTER PLATE
1. Remove the ceiling tile.
2. Using the adapter plate as a template, cut
a hole 3.5 inches (9 cm) in diameter in the |
|
| CEILING TILE |
ceiling tile for the back box. Punch four |
|
| |
|
|
| |
screw holes in the ceiling tile. |
|
| |
|
|
| |
3. Attach the back box to the ceiling tile and | MOUNTING |
| BACK BOX |
HARDWARE |
| ||
adapter plate with the four |
|
| |
(SUPPLIED) |
|
| |
screws. |
| MOUNTING TO CEILING TILE | |
|
| ||
4.Replace the ceiling tile.
5.Remove an adjacent ceiling tile and connect the video cable.
6.Connect the power wires.
•For 12 VDC, connect the 24 VAC/12 VDC (red) and GND (black) wires to input power. The blue wire is not used.
•For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power. The black wire is not used.
INSTALL CAMERA
WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting the camera. This applies to all models.
1.Some indoor installations do not require a heater. If the installation does not require a heater, remove the heater board from the camera assembly. To remove the heater apply pressure and press on the corner of the board.
2.12 VDC Operation Only: The camera is set for 24 VAC operation at the factory. For
12 VDC operation, remove the jumper from the 24 VAC position and install it on the 12 VDC position.
24 VAC JUMPER
12 VDC JUMPER
HEATER
BOARD
VIDEO
CONNECTOR
HEATER
CONNECTOR
6 |
