Turn on power to the camera and monitor.

3.If the heater is installed, plug the heater connector from the camera into the mating connector inside the base. Plug the video connector from the camera into the mating connector inside the base.

Turn on power to the camera and monitor.

VIDEO

CONNECTOR

Proper camera orientation:INSTALL DOME AND TRIM RING HEATER

CONNECTOR

4.Always make sure the tab on the camera bracket is pointing out of the enclosure (away from the ceiling or wall). Gently squeeze the bracket, place it against the shoulder inside the back box, and then gently release.

Proper camera orientation:

CAMERA BRACKET

TAB ALWAYS POINTS NOTE: The screws are installed at an angle.

OUT OF THE

ENCLOSURE

Ceiling Mounting: The camera bracket tab points out of the enclosure, and the top of the camera is pointed in the opposite direction.

TOP OF

CAMERA

CAMERA BRACKET

TAB ALWAYS POINTS

OUT OF THE

ENCLOSURE

Wall Mounting: The camera bracket tab points out of the enclosure, and the top of the camera points up towards the tab.

INSTALL DOME AND TRIM RING

Place the trim ring and dome over the back box. If the dome has a liner, position the viewing window over the lens of the camera. Tighten the tamper-resistant screws with the supplied 1/8-inch hollow screwdriver bit.

NOTE: The screws are installed at an angle.

C2410M-J (2/08)

7

Page 7
Image 7
Pelco C2410M-J manual Install Dome And Trim Ring, Turn on power to the camera and monitor, Proper camera orientation