Installation

PARTS LIST

The DF8 shipping carton contains two boxes. Inspect each box to make sure all parts are present.

BACK BOX

1Back box

1Parts bag

1Flat washer

1Split lock washer

1Screw

1Thread compound

LOWER DOME

1Acrylic lower dome with trim ring

1Parts bag

1O-ring

1O-ring lubricant

1Loctite® threadlocker

BACK BOX

PENDANT MOUNT

NOTE: If installing outdoors, make sure the back box is properly sealed to keep moisture out.

1.Install the mount for the pendant dome. Refer to the instructions supplied with the mount.

2.Bring the wiring for the dome through the mount. Refer to Table A and Table B for wiring distances.

3.Loosen the nut that holds the tilt table assembly to the base of the back box. Move the tilt table assembly as necessary and bring the wiring into the dome. Re-center the tilt table assembly and hand-tighten the nut.

4.Apply thread compound (supplied) to the threads on the back box and screw the back box into the mount.

Figure 1. Installing Pendant Mount and Back Box

C2433M-D (9/06)

5

Page 5
Image 5
Pelco C2433M-D manual Installation, Parts List, Back BOX