6Pelco Manual C2434M (7/01)
INSTALLATION OF PENDANT MODELS

STEP 1 - DISASSEMBLE BACK BOX

a. Turn the thumbscrew and open the hinged door located
inside the back box.
01082
01081
01080
b. Unscrew the three Phillips screws located underneath the
hinged door. Remove the inside portion of the back box.
c. Remove the inside mounting plate by loosening the three
Phillips screws.

STEP 2 - PREPARE INSTALLATION AREA

NOTE:

If installing outdoors make sure the installation is properly sealed to keep moisture out.

Prepare cable and wiring for the system. Refer to Tables A and B in the
Appendix
for wiring distances.
There are three different methods of installation:
1. Direct Mounting to a Wall – Use the mounting side of the octagonal back box as a template and mark the three fastener holes
and conduit hole onto the mounting surface. Set the back box to the side and prepare the holes for the installation.
2. Corner Mounting – Refer to the instructions supplied with the CLCCM corner mount.
3. Pole Mounting – Refer to the instructions supplied with the CLCPA pole adapter.