Pelco C3426M-A (5/07) manual Plaster Ring Installation, Voltage, Red Wire

404 PLASTER RING INSTALLATION

NOTE: You should install the camera module into the back box before installing the back box into the cover. When installing the back box into the cover, rotate the camera module to access the mounting holes (refer to Camera Module on page 16 for more information).

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

2.Pull video and power wires into the cover. Use up to three supplied 6-32 x 0.75-inch Phillips pan head screws or two supplied 8-32 x 0.75-inch Phillips pan head screws to attach the cover to an installed 404 plaster ring. Use stainless steel hardware when installing the system outdoors.

3.Connect the video cable/wires:

•BNC: Connect the BNC connector from the unit to a mating BNC connector.

•UTP: Blue wire = Video +

Gray wire = Video -

4. Connect the power wires.

Voltage	Red Wire	Black Wire
12 VDC	+	Ground
24 VAC	~	~

AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.

NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.

C3426M-A (5/07) 13