After incorporating the enclosure into the wall structure, follow the steps below to complete the installation.
1.Remove the appropriate
2.You can access the inside of the enclosure from either the front or rear. Use the supplied Tampruf #10 socket (fits
•The hinged front swings down after you remove the two Tampruf screws.
•The rear plate comes off after you remove the four Tampruf screws.
3.The tamper switch comes with normally open and normally closed contacts. To wire the tamper switch:
•For a normally open circuit, use the OPEN and COMMON terminals.
•For a normally closed circuit, use the CLOSED and COMMON terminals.
4.Mount the camera and lens to the tilt table.
5.Make all appropriate connections (for example, camera power, video, and lens).
6.Position the camera and tighten the
7.Close the cover (or replace the rear plate) and check that all components clear. Secure with the
MAINTENANCE
Performing maintenance at regular intervals will help prolong the equipment’s operational life and appearance. Regularly clean the Lexan® window with a mild
SPECIFICATIONS
MECHANICAL |
|
Window: | |
Window Viewing |
|
Area: | 3.50 in. H x 4.00 in. W (8.89 x 10.16 cm) |
Camera Mounting: Adjustable tilt table
Maximum |
|
Camera/Lens |
|
Size: | Accepts camera and lens combinations (including BNC connector) up to: |
| 8.0 in. L x 6.0 in. W x 6.0 in. H (20.32 x 15.24 x 15.24 cm) |
Enclosure |
|
Mounting: | Replaces |
Security: | |
ELECTRICAL |
|
Cable Entry: | Two cable |
| eter conduit |
Tamper Switch: | |
| connect. N.O./N.C. clearly marked on switch body. 10 A maximum switch- |
| ing current, 125 V maximum switching voltage. |