Pelco C491M-D dimensions Important Safeguards And Warnings, Description, Installation, U L Listed

®

300 W. Pontiac Way,

Clovis, CA 93612-5699

USA

In North America & Canada:

Tel (800) 289-9100

FAX (800) 289-9150

DataFAX (800) 289-9108

International Customers:

Tel (1-559) 292-1981

FAX (1-559) 348-1120

DataFAX (1-559) 292-0435

Pelco Online http://www.pelco.com

U® L LISTED

C491M-D (3/99)

HS4100BH

High-Security Camera Enclosure

IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.

1.Installation and servicing should only be done by qualified service personnel and conform to all local codes.

2.Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclo- sure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture.

3.Only use replacement parts recommended by Pelco.

4.The installation method and materials should be capable to supporting four times the weight of the enclosure, pan/tilt, camera and lens combination.

5.The camera and lens combination shall not exceed 20 pounds (9.06 kg).

The product and/or manual may bear the following marks:

This symbol indicates that danger-
ous voltage constituting a risk of
electric shock is present within this
	C A U T I O N :
unit.
	RISK OF ELECTRIC SHOCK.
This symbol indicates that there are
	DO NOT OPEN.
important operating and mainte-
nance instructions in the literature
accompanying this unit.

Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.

DESCRIPTION

The HS4100BH is a high-security camera enclosure designed to be mounted in indoor walls in applications requiring maximum protection from vandalism, such as prisons and detention cells.

There is no exposed mounting hardware holding the enclosure to its mounting surface be- cause the HS4100BH replaces a half-size concrete block during construction of the wall. The HS4100BH is made of heavy-gauge steel and is equipped with a window of 1/2-inch (1.27 cm) thick, impact-resistant Lexan®.

The HS4100BH accepts most CCD cameras with fixed focal length lenses and some motor- ized zoom lenses. Access to the inside is through the front or rear with a specially designed tool, so the enclosure cannot be opened by unauthorized people. In addition, a factory-in- stalled tamper switch is mounted on the secured access cover.

INSTALLATION

The following parts are supplied:

1	Enclosure
1	Tampruf #10 socket, 1/4-inch drive

The HS4100BH is designed to be installed in a concrete block wall during construction. The enclosure’s dimensions allow it to replace a half-size block.

Before installing the HS4100BH enclosure in a wall, make certain the wall detail and construc- tion can support the full weight of the enclosure plus the camera and lens. The HS4100BH must not be considered a structural component in a wall. Make sure during construction that the access panels are not obstructed by mortar.