Pelco C493M-G Installation

6 C493M-G (11/97)

Installation

NOTE:

The four (4) fasteners required to secure the HS1500 to a wall (minimum 3/8” diameter recommended) are not supplied.

Before installing the HS1500 to a wall, make certain that the mounting surface is able to support the full weight of the enclosure plus the camera

and lens.

The tilt table and tilt table mounting brackets may be removed to provide adequate clearance for mounting the enclosure.

To mount the enclosure to a wall (tight to the ceiling), follow the steps outlined below.

1. Remove the cover from the mounting bracket. A special socket is provided (ﬁts 1/4" square drive).

2. Using the mounting bracket (see Figure 4) or the template provided, mark and drill holes in the mounting surface.

NOTE:

A plate is provided to prevent access through the top of this enclosure. If needed, it is mounted with the mounting bracket using the

same mounting holes and hardware

3. Attach the enclosure with the required fasteners.

4. Route the required cables through the back and/or top.

5. Mount the camera/lens to the tilt table.

6. Make all appropriate connections (i.e., camera power, video (coax), lens).

7. Position the camera and tighten the 1/4-20 fasteners to secure the tilt table in place.

8. Replace the cover and check that all components clear. Secure the cover with the 1/4-20 “Tampruf” screw provided.

To mount the HS1500 enclosure mid-wall, use the optional hood, HS1500H, and

perform the following steps (see Figure 1):

1. Determine the position for the hood. Using it as a template, mark and drill

holes in the mounting surface.

2. Attach the hood with the required fasteners (minimum 3/8" diameter

recommended).

3. Continue with steps 1-8 listed above in Ceiling Mounting section.

Figure 1. HS1500H Installation